2008 Nissan Altima Blend Door Actuator Location
Paragraph 1:
The 2008 Nissan Altima Blend Door Actuator is located on the passenger side of the vehicle behind the glove box. The actuator is responsible for controlling the blend door, which is the mechanism that regulates the temperature of the air that enters the cabin of the car. It is a small, plastic part that is connected to the blend door with a cable. To access the actuator, the glove box must be removed.
Paragraph 2:
To remove the glove box, the first step is to remove the glove box door. This is done by removing the two screws at the bottom of the glove box door. After the screws are removed, the door can be gently pulled away from the glove box. Once the glove box door is removed, the glove box must be moved out of the way. This can be done by pulling out on the glove box and then lifting it up.
Paragraph 3:
After the glove box is out of the way, the 2008 Nissan Altima Blend Door Actuator can be accessed. It is held in place by two screws. Once the screws are removed, the actuator can be gently pulled away from the blend door. The actuator is connected to the blend door with a cable. This cable must be disconnected before the actuator can be removed.
Paragraph 4:
Once the actuator is removed, it can be replaced with a new unit. The new actuator must be connected to the blend door before it can be reinstalled. The cable must be reconnected and the two screws must be reinstalled to secure the actuator in place. After the actuator is reinstalled, the glove box can be reinstalled and the glove box door can be secured with the two screws.
Paragraph 5:
Replacing the 2008 Nissan Altima Blend Door Actuator is a relatively simple job that can be completed in about an hour. It is important to note that the air conditioning system must be recharged after the actuator is replaced. This will ensure that the system is working properly and that the air entering the cabin of the car is at the desired temperature.
Nissan Heater / A/C Blend Door Replacement Without Removing Dash
2008 Nissan Altima Blend Door Actuator Location. To access the mode door motor you will have to remove the instrument lower panel on the driver's side. Then disconnect the harness from the motor. Remove the screws holding. The actuator would be the blend door actuator. It's located behind the glove box. I'll post a diagram and instructions below. Let me know if manually moving it helps. AIR MIX. 639 161K views 3 years ago Yes, it can be done. I changed the heater / A/C blend door in a Nissan Titan, removing only the glove box. This job would require removing the dash at.
Yes, it can be done. I changed the heater / A/C blend door in a Nissan Titan, removing only the glove box. This job would require removing the dash at the dealer and costs over $1,000. I did it in under 2 hours for $30. Symptoms of a bad blend door are clicking or no heat. Update: DO NOT USE Dorman 604-970. Use the factory part 27743-ZP00A or you'll be changing it again in a few years! For no heat conditions: first check the temperature of...