Home  ›  Articles

2010 Nissan Murano Ac Pressure Switch Location

Written By




The 2010 Nissan Murano has an air conditioning pressure switch located behind the glove box. It is the same switch used in the 2009 model. It is a black plastic switch that is connected to the AC compressor. The switch is mounted to the firewall and is secured by two 10mm bolts. To access the switch, you will need to remove the glove box and the lower trim panel. You will also need to disconnect the AC compressor from the firewall. Once the switch is disconnected, it can be replaced with a new one.


The air conditioning pressure switch is responsible for monitoring the pressure of the AC system. If the pressure is too high or too low, the switch will activate the compressor clutch, allowing it to cycle on or off depending on the pressure. If the pressure switch is malfunctioning, it can cause the AC system to not function properly.


When replacing the AC pressure switch, it is important to use a quality switch that is designed for the Murano. It is also important to follow the directions provided in the service manual to ensure that the switch is installed correctly. If the switch is not installed correctly, it could cause more problems with the AC system.


It is also important to check the AC system for any blockages or leaks before installing the new switch. If any of these issues are present, they should be addressed before installing the new switch. By following these instructions, you can ensure that the 2010 Nissan Murano AC pressure switch is installed correctly and that the AC system is functioning properly.

SYMPTOMS OF A BAD AC PRESSURE SWITCH


2010 Nissan Murano Ac Pressure Switch Location. Charged it with 2 cans to spec (1.1Lb) and its blew in the mid 40's to 50's and it was 80F out. Went it engine bay and saw and heard that there was pressure/refrigerant. http://www.aliexpress.com/store/product/Genuine-AC-Transducer-Pressure-Switch-For-Nissan-2010-42CP8-11-Z20Z-C27-921361FA0A-921366J010-921366J001-921363Z600/3... The switch is on top of the left end of the condenser. It has a three-wire harness connected to it. It uses an o-ring to seal it, so put some refrigerant oil on the new.


In this video, you will learn 4 symptoms of a bad ac pressure switch. Watching this video will help you diagnose if it is time to replace your ac pressure switch. You will also learn how an ac pressure switch works. This video also teaches you where the ac pressure switch is located. Symptoms of a bad ac pressure switch that you may experience are an engine light with codes P0530, P0531, P0532, P0533, ac compressor not turning on, ac blowing...