Home  ›  Articles

Nissan Frontier Blend Door Actuator Replacement

Written By




Replacing a Nissan Frontier blend door actuator is a necessary task to keep your vehicle running smoothly. The actuator is a small, motorized device that directs air from the HVAC system into the cabin of the vehicle. If the actuator fails, it can cause the air inside the cabin to become too hot or too cold, making it difficult to maintain a comfortable temperature. Fortunately, replacement is relatively simple and can be done in a few steps.


First, you will need to purchase a new actuator. It is important to buy one that is specifically designed for your make and model of the Nissan Frontier. This will ensure that it fits correctly and performs as expected. You can typically find these parts at any auto parts store.


Once you have the new actuator, you will need to install it. First, locate the old actuator and disconnect it from the HVAC system. Then, carefully remove it from its mounting bracket and discard it. Next, attach the new actuator to the mounting bracket and reconnect it to the HVAC system. Finally, turn on the vehicle and test the new actuator to make sure it is functioning correctly.

Replacing a Nissan Frontier blend door actuator is a relatively straightforward process. While it may seem intimidating at first, it is important to remember that with the right parts and a few simple steps, you can have your vehicle running smoothly in no time. With a little patience and some careful work, you can be sure that your HVAC system will be back up and running in no time.

2015 Nissan Xterra - Mode Blend Door Actuator Replacement


Nissan Frontier Blend Door Actuator Replacement. The average cost for a Nissan Frontier HVAC Air Door Actuator Replacement is between $128 and $138. Labor costs are estimated between $39 and $49 while parts. 2005-2019 Nissan Frontier Actuator Assembly Part Number: 27743-ZH10A Vehicle Specific Other Name: Actuator Assy; Actuator Manufacturer Note: TEMP Replaces: 27443.


Replacement of the Mode door actuator in my 2015 Nissan Xterra. Some people call it a blend door. This is the mode door, it's on the left hand side of the dash, drivers side. Easily accessible just above and to the right of the gas pedal. Remove the wiring harness and three screws and out it comes. Pop the new one in and good to go. Likely the same replacement procedure for all second gen Xterra's 2005-2015.. Maybe even first gen. Double the...